Page 1 of 1
Is there a way to move dots and lines as a set?
Posted:
Sun Sep 10, 2006 8:52 pmby JLSJ
I setup my lines and dots for morphing between picture 1 and picture 2. When I go to set up the morph between morph 2 and 3 is there a way to move my dots as a set instead of individually?[/b]
Posted:
Sun Sep 10, 2006 10:08 pmby Ark
I'm not sure what you mean "move the dots" - are you copying and pasting dots between morphs?
Posted:
Wed Nov 15, 2006 11:15 pmby usanyou
on another note, is it possible to group the dots and rotate them?
Posted:
Wed Nov 15, 2006 11:20 pmby Ark
There is no rotate tool in Morpheus at this time. Perhaps in the future. You can select any number of dots and copy/paste and drag them around in groups though.
Posted:
Wed Nov 15, 2006 11:34 pmby usanyou
(you're going to hate me - this is my 2nd troubleshooting topic) ...
i know this will be obvious, but ... how do i drag these bloody dots around?
Posted:
Thu Nov 16, 2006 12:00 amby Ark
When using the select dots tool, just click and drag on any of the selected dots to drag them. You can read more about the 3 dot tools at
http://www.morpheussoftware.net/morpheu ... p.php#dots
Posted:
Thu Nov 16, 2006 12:23 amby usanyou
ok - i've read this as well and it did nothing for me the first time.
... but that's just becuz i wasn't clicking on an actual dot after defining my selection. i was clicking anywhere within my box thus de-selecting my dots. go figure!
well, that's 2 for 2 for the night. you can give yourself a pat on the shoulder and call it a day. :D
i think i need to concentrate more before i ask any more Qs.
thx kindly for your help ... and patience!