Page 1 of 1

Duplicating Morphs

PostPosted: Thu Dec 06, 2012 10:21 am
by SrFrog
Is there a way to duplicate a Morph in a layout without re-creating the whole sequence?

I want to run a Morph 2 times, then run a couple more, then run the first one again but only one time.

Re: Duplicating Morphs

PostPosted: Thu Dec 06, 2012 10:44 am
by Ark
You can load the same set of pictures into another morph in your timeline, then copy and paste the dots from the appropriate other copies of the pictures onto the new ones.
Just select-all, copy, then go to the other picture, and paste.

Re: Duplicating Morphs

PostPosted: Thu Dec 06, 2012 7:16 pm
by SrFrog
Thank you; that'll save a lot of time creating complicated layouts.

Re: Duplicating Morphs

PostPosted: Thu Dec 06, 2012 7:52 pm
by SrFrog
Faster - but just an FYI for others - when you paste the dots into the new pix, they will only line up on one side. You still have to move them into position on the 2nd picture.

Have I got this right?

Re: Duplicating Morphs

PostPosted: Thu Dec 06, 2012 8:41 pm
by Ark
You can paste dots from 1 picture at a time. If you have a morph of two pictures (one to a second) then you need to copy/paste two times, once for each picture.

Re: Duplicating Morphs

PostPosted: Fri Dec 07, 2012 8:42 am
by SrFrog
That works. I think I was trying to work with too many pictures in the workspace at once and just confused myself.

When I start from scratch and do it like you said it works fast and easy.

Thank you.