Morpheus Software Support Forums

I've got the warp down from an original to the warped version of the original.

The question is; how do I take that modified original and bring it back to the original condition?

My preview shows a smooth warp, and then it "jumps" back to the beginning and flows until jumping back to the beginning.

I just want a full 360 and not only 180, if that makes sense.

Thank you.

In Timeline Options you can change Render Direction to Both Ways.

OK! Very Good! Thank you! I had read some related posts, the the solutions were a bit tedious and confusing. This is so easy and convenient.