morph speed

[luckypierre]

I made a 40 picture morph of my grand daughter, I have the morph set at:
60, 00, 00.....
the "TIMELINE OPTIONS" are set at:
"QUALITY" @ 100...
"RENDER SPEED" 1......
"FRAMES PER SECOND" @ 20.00.

When the preview reaches half way it starts to get really slow. Is there anything that I can do to get the whole morph to travel at the same speed as the begining of the preview?

[Ark]

What do you mean 60,00,00?

The length of each morph can be set individually in that morph's Morph Options window.

[luckypierre]

Frames in this morph: 60
Frames to hold for at start: 0
Frames to hold for at end: 0

This is what I set it for and all 40 pictures are set the same, so I can't seem to understand why after previewing the first 20 or so pictures that it would suddenly show the next 20 at a much slower rate than the beginning 20.

Thanks again for your assist.

[Ark]

If you have 40 pictures, and all 39 morphs are specifically set to 60 frames long, then there is no way the morph will slow down at any point. Render it to a file instead of using the preview window inside the program.

[Carver]

I do not understand "a 40 picture morph." Does that mean using 40 different photos?